Loading... Please wait...

Categories

Our Newsletter


Sort by:

Mercury Outboard Racing

  • Mercury Racing Sid Bass Leg & Clamp Assembly
    $1,250.00 Mercury Racing Sid Bass Leg & Clamp Assembly
    Sid Bass Leg on a Mercury clamp assembly.  Has a drive shaft and coupler.  Only issue is the steering bar mounting holes are not in the correct spot so, that will have to be corrected.

  • 30H 55H Reed Cages, Set of 2
    $185.00 30H 55H Reed Cages, Set of 2
    Faces have been honed.  Real nice set.

  • Mercury Racing 25SS Coil Covers
    $10.00 Mercury Racing 25SS Coil Covers
    Nice.  No damage.

  • Flywheel, Mercury, Mark, 4cyl Electric Start
    $150.00 Flywheel, Mercury, Mark, 4cyl Electric Start
    Large taper, 59 teeth, requires a 10 tooth starter drive gear.  No charging magnets so it will turn up more RPM'S on "H" motors.  Works with either cowl pictured.  NOTE:  Sometimes shims, (washers) are...

  • Mercury C Serivce Racing Powerhead - Mark 30
    $1,500.00 Mercury C Serivce Racing Powerhead - Mark 30
    This is a MK30 powerhead built to run in the "C" Service Racing class.  Features:  Block has compression stuffers, welded in; Turner 2-ring racing pistons;  Carter carbs, crankcase has been modified for carbs;...

  • Bayer 4 Cylinder Exhaust Plate, 30 40 44ci, Used
    $150.00 Bayer 4 Cylinder Exhaust Plate, 30 40 44ci, Used
    Nice shape, missing one stud.  It has 1/4" mounting holes.  If you need it on later blocks with 5/16 holes you will need to open up the mounting holes.

  • Block, Mercury 500, 44ci, Casting 831-1866
    $150.00 Block, Mercury 500, 44ci, Casting 831-1866
    Out of STD spec, needs to be bored.  No broke off bolts.  Casting # 831-1866.  No serial number on block.  This series uses a bolt to block exhaust tuner.  Would make a good mod race block.

  • 31-85114, 31-85113 25XS Type Roller Bearings, Used
    $25.00 31-85114, 31-85113 25XS Type Roller Bearings, Used
    Here's upper and lower, good to run, used crank roller bearings...

  • $50.00 630-8835A2 A4 25XS Type Rod
    Merc 25 rod, same as used on the 25XS motors.  Rod is in excellent condition.  Casting number is 630-7080.  From Mercury they cost $235.00 each...

  • 42471 25XS Reed Block Assy, Used
    $25.00 42471 25XS Reed Block Assy, Used
    Merc 25 reed block assembly.  Same as used on the 25XS.  Part is in real nice shape...

  • 11139A1 25XS Type Co-Pilot Kit, Used
    $40.00 11139A1 25XS Type Co-Pilot Kit, Used
    .Merc 25 co-pilot kit.  Same as used on the 25XS clamp assemblies.  Good used condition...

  • 86992 25XS Type Center Main, Used
    $50.00 86992 25XS Type Center Main, Used
    Merc 25 center main bearing set.  Same as used on the 25XS motors, now NLA from Mercury.  This is in excellent condition...

  • MERCURY OUTBOARD RACING 25XS CARB - USED
    $175.00 MERCURY OUTBOARD RACING 25XS CARB - USED
    SERVICE MOTOR CARB CONVERTED TO A 25XS LINKAGE. IT DOES NOT HAVE A FULL BUTTERFLY. MAY OR MAY NOT NEED A SERVICE KIT.

  • Merc Racing Flywheel Hub - 44XS
    $75.00 Merc Racing Flywheel Hub - 44XS
    Good used condition.

  • 40H 55H Type Clamp Assembly
    $375.00 40H 55H Type Clamp Assembly
    Will go right on a 55H leg.  It is set up for a 55 leg so it has no holes drilled in the co-pilot to anchor to a 40H leg.  You will have to drill two holes if needed.  It is in very nice shape, has no thrumb...

  • 20H Popper Conversion Set Up
    $1,500.00 20H Popper Conversion Set Up
    In as raced condition.  Bottom swivel pin bushing would need to be replaced.  Thumb screws are in okay condition, pads are loose.  It is complete.  Serial tag #786945.  Comes with filler block and...